Knowledge Base:  

Cannot get data from Kenwood TH-K2 radio

Last Updated: 06/22/2020
When the radio is connected to a PC in order to use a programming cable (RT Systems USB-K4Y) and programming software, you MUST configure the SP/MIC jack function prior to making a connection between the radio and the computer.

This is done by settings Menu Item 31 (PC) to On by the following steps. Everything that follows is done from the face of the radio.
  1. Press [MENU]
  2. Turn the Tuning knob to select menu No 31 (PC)
  3. Press [Menu]
  4. Turn the Tuning knob to select "ON"
  5. Press [MENU] to store the settings.
  6. Press any key other than [LAMP]. [Moni/SQL], or [Menu] to exit Menu Mode.

Note: To use a speaker/mic with the radio after programming, repeat these steps with Menu Item 31 set to "OFF" for the speaker/Mic to function properly.



Was this article helpful?

Comments:
 

Related Articles
 > Dual Tone Radios - Radios that can use different tones for encode and decode for the same memory channel.
 > Repeater Access Tones
 >
Firmware Updates

 >
CTCSS Tones

 >
Packet Mode

 >
Groups

 >
Required communication for PC programming on the TH-F6

 >
Instructions for Programming

 >
USB Option

 >
Programmer to radio data transfer

 >
Programming/Control Cable

 >
Communicating with the radio

 >
Packet Connection

 >
Groups

 >
Firmware Updates

 >
Band A and Band B 2M/440Mhz Separation

 >
Name Display

 >
Unable to establish communications with radio

 >
Offset Frequency requirements for the TH-F6