Knowledge Base:  

KRS-710 Installer

Last Updated: 01/24/2020
During installation of the KRS-710 programmer, you will be prompted with the following screen to select the program for the Original (D-710) or newer (D-710G) radio. Be sure to install the correct version of the program for your radio. If you have both radios, install both. If you are not sure, install both.... one will work: the other will not. If the one you install does not work with your radio... run the installer again and install the other one.

Remember: To program the radio, the cable attaches to the PC connection on the back of the radio. BTW... the USB-K5G cable can be used for firmware upgrades on the radio although you may have to reset the com port designation in Device Manager for Kenwood's upgrade program to find it (not hard and we will help if you need us for that change... the upgrade is you to you to complete.)



Was this article helpful?

Comments:
 

Related Articles
 >
Cannot read TM-D710 - Error

 >
Packet Connection

 >
Groups

 >
Firmware Updates

 >
Receive Beep When Scanning

 > Cycling bands in VFO on the TM-D710 and TM-D710G
 >
USB-K5G use on the TM-D710

 >

Cross Band repeat operations on TM-V71 and TM-D710/d710G radios