Knowledge Base:  

User Band Edge in the IC-7300

Last Updated: 12/30/2019
Sequence of operation:

1. Open the program
2. Select SETTINGS then Select the RADIO MENU SETTINGS dropdown item
3. Select SET MODE 3 tab
4. Go to the USER BAND EDGE box
5. At this point, nothing can be modified in this block. There is a message that says:
Put in (User) mode to enable. I have no idea what this means, or how to put it in User Mode.

It is Band Edge Beep on Set Mode 1 that must be set to one of the User options to enable editing of the User Band Edges.


Was this article helpful?

Comments:
 

Related Articles
 >
IC-7300 USB Driver Setup

 >
IC-7300 CI-V Address

 >
IC-7300 Memory Channels

 >
IC-7300 Repeater Operations

 >
IC-7300 Remote Control

 > Silicon Labs Drivers
 >
Cannot Find Valid Baud Rate on IC-7300