Knowledge Base:  
USB-K5G use on the TM-D710

Last Updated: 10/05/2019
Note to staff, I'm also using your USB-K5G Programming Cable with the front panel of my radio connect with its TNC. It's a Kenwood TM-D710GA being used for Winlink. (Connection is on the back of the front panel.)

I'm able to run one cable to the rear of the radio for the Signalink soundcard and reach the TNC via the front panel.

Nice.
We received this information from a customer using the USB-K5G in a little different configuration. Thought you all would like to know if you explore Winlink.


Was this article helpful?

Comments:
 

Related Articles
 >
Cannot read TM-D710 - Error

 >
Packet Connection

 >
Groups

 >
Firmware Updates

 >
Receive Beep When Scanning

 > Cycling bands in VFO on the TM-D710 and TM-D710G