Knowledge Base:  
DR Memories

Last Updated: 10/01/2019
When programming channels into the DR memories, they must have a call sign associated with RTS1 and RTS2, be DV mode to show up in the Gateway CQ section of the "TO" list (Incoming signal) on the radio. While they are set up for other uses and can be used in the Repeater List of the "FROM" selection (outgoing signal), they are not a part of the "To" operations.





This channel will show up in both the To and From selections when making that choice from the face of the radio.




Remember too, you can update the DR Memories list and remove those repeaters you won't be using with the DSTAR calculator that is built right into the programmer.




Was this article helpful?

Comments:
 

Related Articles
 >
IC-9100 USB Driver Setup

 > DVAP Setup
 > D-Star Calc not available in menu
 >
HF DSTAR Activities

 >
Cable Requirements

 >
Send Data to Radio Fails (European Models Only) IC-7100, IC-9100

 > ID 5100 Firmware E3 upgrade
 > DStar Gateway Version 3 ("G3") 11/2016
 > Cable Selection for Programming
 > Tone Mode changes in the E3 firmware upgrade of the ID-5100
 >
IC-9100 Airctaft Receive

 >