Knowledge Base:  
IC-7300 USB Driver Setup

Last Updated: 04/26/2016
The IC-7300 has built in USB circuitry. A USB-A to USB-B cable can be used to connect the radio to the computer through the USB port on the back of the radio..

If the radio is connected while it is on, the drivers for this USB circuitry will not load. Without the drivers loaded, there will be no communication between the radio and the computer for any program. Checking in Device Manager, there will be no listing for the radio under Ports - Com and Lpt.

Turn the radio off, count to 10, turn the radio back on. The power on sequence will trigger New Hard Ware found and driver installation.


Was this article helpful?

Comments:
 

Related Articles
 >
IC-7300 CI-V Address

 >
IC-7300 Memory Channels

 >
IC-7300 Repeater Operations

 >
IC-7300 Remote Control

 > Silicon Labs Drivers
 >
Cannot Find Valid Baud Rate on IC-7300

 >

User Band Edge in the IC-7300