Knowledge Base:  
FT-991 Scanning
Last Updated: 11/04/2016
After completing Communications | Send data to radio, you must power the radio off and back on for the Scanning process to again be functional. The radio does something with the data during startup to re-engage the scan process.

Was this article helpful?

Comments:
 

Related Articles
 > Dual Tone Radios - Radios that can use different tones for encode and decode for the same memory channel.
 > Repeater Access Tones
 > VX-8 Differences (8D vs 8G)
 >
MS Error when scanning Yaesu Radios with Banks

 >
Cable communication problems in Ham Radio Deluxe

 > Yaesu USB Com Port Drivers
 > FT-991 Using the Multi Knob for Changing between Memory Channels
 >
Sept 2017 Firmware Upgrade for Yaesu FTM-400 and FTM-100