Knowledge Base:  
Yaesu USB Com Port Drivers
Last Updated: 01/26/2016

Download the drivers for the SCU-19 cable for the FT1D and the SCU-20 cable for the FTM-100 and FTM-400 distributed by Yaesu.

Click on the link below on the link to download the executable file to install the drivers.

Yaesu Prolific Drivers

While RT Systems can offer assistance for using these cables with the RT Systems programmers for the radios, we are limited in what we can do for support if the drivers fail to install. For additional support of these cables, contact Yaesu directly.



Was this article helpful?

Comments:
 

Related Articles
 > Dual Tone Radios - Radios that can use different tones for encode and decode for the same memory channel.
 > Repeater Access Tones
 > VX-8 Differences (8D vs 8G)
 >
MS Error when scanning Yaesu Radios with Banks

 >
Cable communication problems in Ham Radio Deluxe

 > Programming the FTM-400 via the SD Card
 > Getting Started with the ADMS-FT1D Programmer
 >
Quick Guide to Reading and Writing the FTM-400 Radio

 > Yaesu's Firmware Upgrade for the FTM-400
 > FTM-400 Checking Radio Firmware Version
 > FT-991 Scanning
 >
Channel Scan error: "ERROR No MEMORY"

 >
FTM-400 Out of Band Receive (AM, 174-400Mhz and 480-999.99MHz)

 > FT-991 Using the Multi Knob for Changing between Memory Channels
 >
Sept 2017 Firmware Upgrade for Yaesu FTM-400 and FTM-100

 > Position Comment - Custom... not really
 > PMS Steps
 >
Auto Step and Limit Memory Scanning

 > APRS SSID (Station identifier)
 >

APRS Text Messages


 >
Different CTCSS tones for Tx and Rx

 >
Call sign setup for FTM-400