Knowledge Base:  
Navi - not working, radio stays in standby

Last Updated: 10/28/2013
"Navi" won't work, radio stays in "Stdby" - Radio needs to be set to GPS.  Go into "Radio Menu Settings", select the APRS/GPS tab, in about the center of the page, "My Position" needs to be set to GPS, so the radio can tell where you are to navigate or "Navi".

We have also found that the radio struggles to "Navi" or navigate over about 600 miles.


Was this article helpful?

Comments:
 

Related Articles
 >
APRS/Packet Sort Filter

 >
DCS Polarity

 >
Firmware V 1.2 Update Notes

 >
Half Deviation

 >
Lock Type

 >
Mono or Dual Receive Toggle

 >
Programmed frequencies do not show on radio.

 >
Radio Locks Up

 >
S Meter Indicators

 >
Scanning

 >
USB-81 Cable

 >
WX Channels

 > Cannot Start Cross-Band Repeater Mode