System Requirements:
A PC running
Windows 7 (32 or 64 bit),
Windows 8 or 8.1 (full version), Windows 10.

Tech Support:
303-586-6510
Tech Support Hours:
Monday-Friday
8:00AM - 5:30PM
Mountain Time


Saturday
9:00AM - 1:00PM
Mountain Time
Email:
 
Sales:
Phone: 800-921-4834
Fax: 770-216-1836
Sales Hours:
Monday-Friday
8:00AM - 5:00PM
Mountain Time
Email Sales:
 
RT Systems
510 Compton St, #105
Broomfield, CO 80020
 
Join Our
Mailing List!

Enter your e-mail address
to receive programming
tips, promotions or
other information from
RT Systems.

 Visa MasterCard Discover and American Express


Knowledge Base:  

Page of 1
FT-857/897 Shortcut Does Not Open Programmer and Icon Is Missing

This issue sometimes comes up if you have an installation disc from 2012 or earlier. To resolve it, please follow the instructions below: Right click on the shortcut for the programmer and click pro
Installation of the Programmer on Windows 8, Windows 8.1 and Windows 10
On some machines running Windows 8, 8.1 and Windows 10, installation of the RT Systems Programmers will display an error warning of Windows version compatibility. This seems to happen on machin
No Radio Modules Were Found Error

This error most commonly occurs upon trying to start up the radio programmer immediately after installation. There are two different methods that can help fix this problem - we recommend you try meth
dllx.600 or 501 or LOAD error

Incompatibility mode issue - right click on radio icon, down to properties, then center tab of compatibility - DO NOT want a mode checked, if it is checked, un-check "Run this program in Compatibilit
Radio won't go into TX or RX after CLONE

Radio goes into "CLONE" but can't get into TX or RX - is the keypad locked, is there a small padlock showing on the screen? To unlock, please see page 13 of the owner's manual. (Press the (FW) key th
Error running Settings screen in VX-7 Programmer
When accessing the settings screens in the VX-7 programmer a fatal error is raised concerning a control that cannot be created. To eliminate this error, run the correction file from the link. 
IC-7300 Memory Channels

To change between memory channels on the IC-7300, first touch the VFO/Memory Icon on the right of the screen. When the window opens, select Memory. The Icon will change to MEMO when you are in memory