System Requirements:
A PC running
Windows 7 (32 or 64 bit),
Windows 8 or 8.1 (full version), Windows 10.

Tech Support:
303-586-6510
Tech Support Hours:
Monday-Friday
8:00AM - 5:30PM
Mountain Time


Saturday
9:00AM - 1:00PM
Mountain Time
Email:
 
Sales:
Phone: 800-921-4834
Fax: 770-216-1836
Sales Hours:
Monday-Friday
8:00AM - 5:00PM
Mountain Time
Email Sales:
 
RT Systems
510 Compton St, #105
Broomfield, CO 80020
 
Join Our
Mailing List!

Enter your e-mail address
to receive programming
tips, promotions or
other information from
RT Systems.

 Visa MasterCard Discover and American Express


Knowledge Base:  
Memory Banks

Last Updated: 08/07/2013
To access the memory banks in the IC-2300 once they are programmed: 

Press M-Call to access memory mode (at this point all your memory channels will be available when you turn the tuning knob.)

Press the [Bank/Option] key on the HM133V mic (upper right).  This key is found only on the mic.  There is not a corresponding key on the face of the radio. 

Note:  This is a very strange press.  It's REALLY short... it is really shorter than short... a tap might describe it better.  

Your expected response on the radio is "BANK --- m --"  If anything else appears, press the PTT to leave this mode and try again. 

Rotate the tuning knob on the desired bank.  You may go past a frequency display during this step.  Just keep going until the selected bank appears. 

Press PTT to leave this mode.  Your selection will appear at the right of the display.

If bank linking is not engaged, when you turn the knob or press the up/down keys only the channels assigned to that bank will be included.

If banks are linked AND bank linking is engaged, all the channels of the linked banks will be displayed. 


Bank Linking

The fields to control Bank Linking are found in the programmer under Settings | Radio Menu Settings | Common tab | Bank Link.  Check the boxes for the Banks to be  "joined"  when Bank Linking is engaged.

The same option is found on the F1 and F2 tabs.  Bank linking can be configured differently in each of those.  Remember, once you access the F1 or F2 configuration from the face of the radio, you cannot return to the Common configuration without again programming the radio from the computer.  

Note:  Bank linking is not only for scanning.  When is engaged, all memory channels in all banks will be available when scanning or tuning manually.   Those memory channels not assigned to a bank will be excluded. 



 

Was this article helpful?

Comments:
 

Related Articles
 > Repeater Access Tones
 >

IC-2100 Narrow Band Operations


 >
Radio buttons not working

 >
No programmer for this radio

 >
Software and cable

 >
Software and Cables

 >
Software and Cables

 >
Dual Display

 >
Control Cable

 >
No programmer for this radio

 > Banks
 >
Cable Information

 >
Name Display

 >
Skip Channels

 >
Data Transfer

 >
Details for IC-756

 >
Port for Data/Programming Cable

 >
D-STAR Calculator not available

 >
Cable Requirements

 >
Banks - Accessing on the radio after programming

 >
D-STAR Settings & Calculator grayed out

 >
Buttons not working on radio

 >
CI-V Baud Rate affects programming