System Requirements:
A PC running
Windows 7 (32 or 64 bit),
Windows 8 or 8.1 (full version), Windows 10.

Tech Support:
303-586-6510
Tech Support Hours:
Monday-Friday
8:00AM - 5:30PM
Mountain Time


Saturday
9:00AM - 1:00PM
Mountain Time
Email:
 
Sales:
Phone: 800-921-4834
Fax: 770-216-1836
Sales Hours:
Monday-Friday
8:00AM - 5:00PM
Mountain Time
Email Sales:
 
RT Systems
510 Compton St, #105
Broomfield, CO 80020
 
Join Our
Mailing List!

Enter your e-mail address
to receive programming
tips, promotions or
other information from
RT Systems.

 Visa MasterCard Discover and American Express


Knowledge Base:  
FT-991 Using the Multi Knob for Changing between Memory Channels
Last Updated: 11/04/2016
So, you have programmed the radio with the memory channel information you want. Now you want to access that information.... Not so easily done on the FT-991 or FT-991A.

Follow these steps for the functionality you're looking for:
  1. Power on the radio (remember, you must power it off and back on after programming)
  2. Press the V/M key (to the right of the large tuning knob)
  3. Notice the indication at the upper left of the screen changes. You want it to be MEM## indicating memory mode.
  4. Press [F] key to access the function keys on the face of the radio. This is a SHORT press. If you hold it too long it will bring up a list of memory channels. This is not what you want.
  5. Use FWD or BACK keys to change to the menu that has MCH in the top row. (The arrows on the right and left of every screen... don't worry about "fat fingers" on this screen. Touching with a fingernail, a plastic pen cap or a pencil eraser will work. You just want something that won't damage the face of the radio.)
  6. Press MCH and watch the indication below the frequency change to MCH.
  7. Now it gets a little tricky to return to the scope display, close the menu and remain in MCH mode. I was able to accomplish it through a series of key strokes using the [F] and [V/M] keys; but I can't tell you the exact sequence as it never seemed to be the same twice depending on what the radio did next.
  8. The object of the exercise is to have the MCH appearing on the face of the radio below the frequency. Then the multi knob will function to change channels
If you want to know more about all the things that multi knob does, see page 22 of the FT-991 Operating Manual. That knob does 20 different things depending on what the radio is doing at the time. Changing memory channels is only one of those 20 things. This is a menu driven knob that will take some getting used to.



Was this article helpful?

Comments:
 

Related Articles
 > Dual Tone Radios - Radios that can use different tones for encode and decode for the same memory channel.
 > Repeater Access Tones
 > VX-8 Differences (8D vs 8G)
 >
MS Error when scanning Yaesu Radios with Banks

 >
Cable communication problems in Ham Radio Deluxe

 > Yaesu USB Com Port Drivers
 > FT-991 Scanning
 >
Sept 2017 Firmware Upgrade for Yaesu FTM-400 and FTM-100