System Requirements:
A PC running
Windows 7 (32 or 64 bit),
Windows 8 or 8.1 (full version), Windows 10.

Tech Support:
303-586-6510
Tech Support Hours:
Monday-Friday
8:00AM - 5:30PM
Mountain Time


Saturday
9:00AM - 1:00PM
Mountain Time
Email:
 
Sales:
Phone: 800-921-4834
Fax: 770-216-1836
Sales Hours:
Monday-Friday
8:00AM - 5:00PM
Mountain Time
Email Sales:
 
RT Systems
510 Compton St, #105
Broomfield, CO 80020
 
Join Our
Mailing List!

Enter your e-mail address
to receive programming
tips, promotions or
other information from
RT Systems.

 Visa MasterCard Discover and American Express


Knowledge Base:  
Cannot Start Cross-Band Repeater Mode
Last Updated: 02/17/2014
To start cross-band repeat mode, turn the radio off, then turn it back on while holding the key to the left of the power button. Then, turn the left dial to option 11 and press the dial twice to start cross band repeat mode.

If the radio does not respond when you press the dial, check the APRS Modem. The radio cannot enter cross-band repeat mode if the APRS Modem is on. You can disable the APRS Modem either using the RT Systems programming software, or directly from the radio's face by following these steps:

  • Press the SET key
  • Turn the left dial to select to APRS/PKT, then press the dial
  • Turn the left dial to E05 APRS MODEM, then press the dial
  • Turn the left dial to select OFF, then press the dial
  • Press the ESC key twice to close the menu mode


Was this article helpful?

Comments:
 

Related Articles
 >
APRS/Packet Sort Filter

 >
DCS Polarity

 >
Firmware V 1.2 Update Notes

 >
Half Deviation

 >
Lock Type

 >
Mono or Dual Receive Toggle

 >
Navi - not working, radio stays in standby

 >
Programmed frequencies do not show on radio.

 >
Radio Locks Up

 >
S Meter Indicators

 >
Scanning

 >
USB-81 Cable

 >
WX Channels