System Requirements:
A PC running
Windows 7 (32 or 64 bit),
Windows 8 or 8.1 (full version), Windows 10.

Tech Support:
303-586-6510
Tech Support Hours:
Monday-Friday
8:00AM - 5:30PM
Mountain Time


Saturday
9:00AM - 1:00PM
Mountain Time
Email:
 
Sales:
Phone: 800-921-4834
Fax: 770-216-1836
Sales Hours:
Monday-Friday
8:00AM - 5:00PM
Mountain Time
Email Sales:
 
RT Systems
510 Compton St, #105
Broomfield, CO 80020
 
Join Our
Mailing List!

Enter your e-mail address
to receive programming
tips, promotions or
other information from
RT Systems.

 Visa MasterCard Discover and American Express


Knowledge Base:  
Scanning

Last Updated: 10/28/2013
Complaint -  After programing both the Left and Right Memories, only the Left memories will scan. When attempt to scan on the right memories the radio displays a message Error "No Memory".  

Response -  In your file you have the Memory Scan Type option for the Right side set to Select Memory.   With this option set, the radio scans only channels marked as Select in the Skip column.  Since there are no channels set to Select there are no memories to scan.

Change the Memory Scan Type to All Memory Settings | Radio Menu Settings| Common tab | Memory Scan Type) or change the Skip type in the Right Memories to "Select". 

Then you will be able to scan on the right side also.

This is not something that the programmer does "magically" to the radio.  While we applaud your experimentation with the radio, this is something that was set in the radio when the initial Get Data from radio was performed.  It has been saved to the file in anticipation of your wanting to use it the way it was found to be set originally.  





Was this article helpful?

Comments:
 

Related Articles
 >
APRS/Packet Sort Filter

 >
DCS Polarity

 >
Firmware V 1.2 Update Notes

 >
Half Deviation

 >
Lock Type

 >
Mono or Dual Receive Toggle

 >
Navi - not working, radio stays in standby

 >
Programmed frequencies do not show on radio.

 >
Radio Locks Up

 >
S Meter Indicators

 >
USB-81 Cable

 >
WX Channels

 > Cannot Start Cross-Band Repeater Mode